Unitech Hand Held Scanner Bedienungsanleitung PDF herunterladen (Seite 17)

Chapter 4

Terminal Interface

Installation

To install the scanner as a terminal interface, you need a DB25 RS232 cable, a

terminal wedge "Y" cable and an AC adapter. See Figure 3 for reference.

Installed as a Terminal Wedge

Installation procedures:

1) Power off the terminal and unplug the communication cable at terminal

side.

2) Install the interface cable as shown in Figure 3. The "Y" cable provided in

Figure 3 is for terminals with female connector on communication port. If

there is a male connector on your terminal, you need a converter to

change that male to female and another converter to change the female

to male on host connector.

3) When the scanner is powered, a long beep sound indicates that the scanner

is ready to use.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 63 64

Keine Kommentare

Unitech Hand Held Scanner Bedienungsanleitung Seite 17