Unitech HT580 Bedienungsanleitung PDF herunterladen (Seite 19)

Supervisor Mode

When entering into Supervisor mode, you will be required to input a password. The

default password is “580”. From the Supervisor settings menu, you are given the

following options:

Communication < COMM >

This feature is used to set up communication ports, options and protocols. Below are all

of the settings and their options.

ITEM OPTIONS DEFAULT

PORT RS232/USB , BLUETOOTH, MODEM RS232/USB

BAUD RATE 9600bps, 19200bps, 38400bps, 57600

bps

Default for both RS232

and Bluetooth

38400bps.

PARITY NONE, ODD, EVEN NONE

DATA BITS 8, 7 8

STOP BITS 1, 2 1

PROTOCOL MULTI, NONE Mult

ADDRESS “A” ~ “Y” or “0” ~ “6” A

Port

The 4 port

interfaces are connected to the same serial port on the HT580. If modem or

RS232 is selected, any output data from the HT580 will be sent to those ports. (If USB

is selected, the HT580 still communicates via serial port emulation.) For Bluetooth,

please refer to the section “Communication” for a guide through Bluetooth

communication setup.

Address

It is necessary to set a unique address if the user wants to identify each terminal

separately for communication. There are 32 different available addresses, “A” ~ “Y” and

“0” ~ “6”.

Chapter 2 Using the Hardware

1. COMM 2. TERM

3.FORM 4. PWR

5.PSWD 6. BAR

7. DIAG 8. SYS

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 36 37

Keine Kommentare

Unitech HT580 Bedienungsanleitung Seite 19