Unitech MP300 Spezifikationen Seite 8
- Seite / 18
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Copyright 2008 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
14
Copyright 2008 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
15
Adding Paper
The printer can print text, bar codes and graphics on thermal receipt paper. See
“Supply Specications” on page 32 for the width, thickness requirements and approved
vendors. Follow these steps to load printer paper:
• Open the paper supply cover by placing your ngers under the “T” pull lever.
Pull up rmly on the supply cover until the lever stops moving.
Please be careful not to force the “T” pull lever too far back.
• Place the paper roll into the paper supply well. Make sure the paper supply
unwinds from the bottom as shown below.
• Position the paper supply between the print-head guides.
• Make sure some supply (2” - 3”) extends beyond the top of the paper supply well.
• Shut the paper supply cover and press close.
NOTE: To prevent any possible damage to the print-head mechanism, it is important to verify that the paper
has not been fastened to the inside core in any way. The paper should be wound on the core in such a way
that the end of the paper will unwind freely from the core. If fastened by tape or glue, the core will be pulled
into the mechanism causing jamming and possible gear damage.
Loading Supplies
Chapter 2
Tearing Paper
The printer’s paper door acts as a tear bar. Pull one edge of the paper against the tear
bar as indicated, then pull down and across against the tear bar to rip the paper.
NOTE: Using the tear bar is the only way to rip the paper. Pulling up and sideways without using the
tear bar can cause a paper jam due to paper misalignment in the print-head mechanism.
- MP300 Mobile Printer 1
- About This Manual 2
- Table of Contents 3
- Getting Started 4
- Chapter 1 4
- A Tour of the MP300 5
- Declaration of Conformity 5
- Communication Options 5
- Installing the Battery 6
- Charging the Battery 6
- Reading the LED Status 7
- Attaching the Belt Clip 7
- Loading Supplies 8
- Chapter 2 8
- Using the Printer 9
- Chapter 3 9
- Communication 10
- Direct IR 11
- Programming Information 12
- Chapter 4 14
- Printer Maintenance 14
- Trouble Shooting 15
- Chapter 5 15
- Chapter 6 16
- Specications 16
- Chapter 7 16
- Printer Supplies 16
- Regulatory Notes and Warranty 17
- Chapter 8 17
Verwandte Produkte und Handbücher für Drucken & Scannen Unitech MP300
Drucken & Scannen Unitech MP200 Spezifikationen
(26 Seiten)
(26 Seiten)
Drucken & Scannen Unitech MP200 Spezifikationen
(18 Seiten)
(18 Seiten)
DeLOCK 87619 manuály
Uživatelské manuály a uživatelské příručky pro Počítačové příslušenství DeLOCK 87619.
Poskytujeme 4 manuály pdf DeLOCK 87619 ke stažení zdarma podle typů dokumentů: Uživatelský manuál
Kommentare zu diesen Handbüchern