Unitech PA982 Bedienungsanleitung PDF herunterladen (Seite 24)

Setting up the Wireless Local Area Network Card

The PA982 is pre-loaded with connection software from Cisco and

Lucent WaveLAN (Agere Orinoco). The PA982 automatically

detects RF cards and then displays this screen during the first-time

installation. Note that you can use one of the following two ways to

set the IP address:

• Obtaining an IP Address via DHCP Server

• Specifying an IP Address

Obtaining an IP Address via DHCP Server

Check with your MIS department to determine whether a DHCP

server is available in your LAN environment. If available, tap the

radio button next to Obtain an IP address via DHCP, and then tap

the OK button.

Specifying an IP Address

If there is no DHCP server in your LAN environment, assign IP

addresses to each PA982 as follows:

1. Tap Start → Settings → Control Panel and then double-tap Network and Dial-up Connec-

tions.

2. Tap the radio button next to Specify IP Address.

3. Input the proper IP address, Subnet Mask, and Default Gateway.

4. Tap the Name Servers tab, and then input the proper Primary DNS, Secondary DNS, Primary

WINS, and Secondary WINS.

To avoid conflict with your LAN environment, consult with your MIS department for the correct

TCP/IP setting.

WiFi Connection

With the embedded WLAN module, you can send and receive signals to a WiFi network then synchro-

nize files.

NOTE: WiFi access requires a separate purchase of a service contract with a wireless service

provider. Contact a wireless service provider for more information.

A wireless network can be added either when the network is detected or by manually entering settings

information. Before doing these steps, determine if authentication information is needed.

1. If present, double-tap the WIFI icon in the notification area

to open the WIFI Properties screen.

2. Select the Wireless Information Tab.

WiFi icon

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 33 34

Keine Kommentare

Unitech PA982 Bedienungsanleitung Seite 24