Unitech HT630 Bedienungsanleitung PDF herunterladen (Seite 17)

HT630 User Manual

3.3.2 SCANNER:

The system software of terminal decodes all major bar code symbologies including Code 39, Code 128,

Codabar, Code 93, I25, EAN, UPC, China Post code, etc. Use the [→] key to toggle among selection in each

category, then press [ENT] to confirm.

SCANNER

Enable / disable bar code decoding.

LASER TRIG MODE

If NORMAL is selected, you must press and hold down trigger to scan

barcode label. If FLASH is selected, you can directly scan barcode

label without pressing trigger key.

LASER AIM

Enable / disable laser beam point target on a distance barcode.

VERIFICATION

Enable / disable double check scanned barcode.

3.3.3 DISPLAY:

Enable/disable power-on logo displays when power-on.

3.3.4 KEYPAD:

Allow user to set UPPER / LOWER case of character.

3.3.5 BLUETOOTH:

Allow user to send scanned barcode data to Bluetooth enabled computer or PDA.

BLUETOOTH

Enable / disable Bluetooth function.

Config

BT MODE: Determine the mode of operation to be SLAVE or

MASTER. If MASTER mode is selected, you can enable

/disable auto connection to available BT devices.

Addr

Display the BT Address.

Find BT devices and addresses, then press [ENT] to connect,

[→] to select the next BT access, [ESC] to leave.

(Available only when HT630 in master mode)

Reset

Restore factory default settings.

BT SETUP

Exit

Leave the BLUETOOTH setting environment.

3.3.6 EXIT:

Leave the SET (setting) environment.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Keine Kommentare

Unitech HT630 Bedienungsanleitung Seite 17