Unitech MS916 Bedienungsanleitung PDF herunterladen (Seite 77)

- 70 -

specific range. To set lengths via serial commands, see Setting Code Lengths

Via Serial Commands.

One Discrete Length - Select this option to decode only those codes

containing a selected length. For example, select Codabar One Discrete

Length, then scan 1, 4, to decode only Codabar symbols containing 14

characters. Numeric bar codes begin on Appendix B. To change the selection

or cancel an incorrect entry, scan Cancel on Appendix B.

Two Discrete Lengths - This option sets the unit to decode only those codes

containing two selected lengths. For example, select Codabar Two Discrete

Lengths, then scan 0, 2, 1, 4, to decode only Codabar symbols containing 6 or

14 characters. Numeric bar codes begin on Appendix B. To change the

selection or cancel an incorrect entry, scan Cancel on Appendix B.

Length Within Range - Select this option to decode a code within a specified

range. For example, to decode Codabar symbols containing between 4 and 12

characters, first scan Codabar Length Within Range, then scan 0, 4, 1 and 2

(single digit numbers must always be preceded by a leading zero). Numeric

bar codes begin on Appendix B. To change the selection or cancel an incorrect

entry, scan Cancel on Appendix B.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 92 93

Keine Kommentare

Unitech MS916 Bedienungsanleitung Seite 77